KVH Industries TracVision R4 Manuel d'utilisateur télécharger pdf (Page 23)

2-12

A Guide to TracVision R5/R4

2.3.5 Connecting the Antenna RF Signal

Cable to the Receiver

1. Route an RF cable up through the roof’s cable

access hole.

2. Connect the RF cable to the antenna’s RF1

connector (see Figure 2-14). Once the cable is

securely connected, loosen the sealing nut at the

base of the RF1 connector and tighten it onto the

end of the RF cable.

3. Connect the other end of the RF cable to the

receiver’s SATELLITE IN connector.

2.3.5.1 Installing Two Receivers and TVs

(North American Systems Only)

To connect a second TV and receiver to the TracVision R5/R4

system, you must connect a second RF cable to the antenna’s RF2

connector (see Figure 2-14). Route the other end of the RF cable

down into the vehicle and connect it dir

ectly to the second

receiver.

KVH recommends the use of

RG-6 or RG-11 (75 ohms) cable

for RF wiring. Use of non-RG-6

or RG-11 (75 ohms) cables will

result in degraded performance.

The KVH warranty does not cover

degraded performance due to

improper wiring.

When shipped from the factory, the

antenna’s RF connectors are

protected with caps. Leave the cap

installed on the RF2 connector

unless you are going to connect a

second RF cable to the

TracVision R5/R4.

RF2 RF1

Figure 2-14

Antenna RF Connectors

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 64 65

Pas de commentaire

KVH Industries TracVision R4 Manuel d'utilisateur Page 23